Stainless Hardware — Tilt Base
The complete hardware set for the Greyline Tilt-Up Base: four 3/8″-16 x 3.25″ pivot bolts, four nuts, eight washers, and eight 1/4″-20 section bolts — in stainless. The pivot is the one joint on the antenna that moves by design, and it lives at ground level where moisture collects. Plated hardware there is on a short clock; stainless ends it.
Check the rest of your hardware while you are down there. Stainless is mildly magnetic, so a light pull on a magnet is normal; plated steel grabs hard, and it rusts. Rust is the verdict. Replace with stainless, always.
The right way to swap it — pivot bolts last, antenna supported — is written up in our assembly documents.
Shipping included. Hand-bagged in Sun Valley, Idaho. Questions: 435-200-4902 — an operator answers.
